C2C caberQU v1

The C2C caberQU v1 board applies a voltage to all pins of a cable and measures which ones are connected to the other end. It features LEDs for each of the 24 pins and even shield. So in total 25 LEDs offer all possible combinations for USB-C receptacle pin usage in different modes:

• USB 3.0/3.1
• USB 3.2/4
• USB 2.0/1.1
• USB Power Delivery
• Alternate Mode
• Debug Accessory Mode
• Audio Adapter Accessory Mode

V1 vs V3 Which one should I buy?

There are two versions available which are mostly identical, but there are a few differences:

• V1 has a standard battery, V2 has a German name brand
• V3 can be used with the case
• V1 has no holes for hanging it somewhere
• V1 has a slightly different sikscreen print

Both V1 and V3 can be used for testing USB C to USB C cables identically. They come with the same manual and have the same LED combinations available.

Why did you make it? 

The amount of possible USB C cable combinations is endless. If you use the wrong cable, data transmission may be slower than possible or certain devices may not work at all. In the USB C standard, the cable plays an important role and has to advertise itself as such. All of them need to have certain pins connected, some need to be grounded, some need to have resistors attached.

What makes it special? 

Unfortunately there is no easy way to extract whether a certain cable can support a certain use case. If a cable has a broken pin, that makes it even worse, due to their unpredictable behavior. The C2C caberQU cable tester solves this once and for all. By flipping the USB connectors, the opposing LEDs for some pins light up due to them not being mirrored. That's on purpose and defined in the USB C standard. The product is sold with one CR2032, the PCB and some basic instructions. The USB C cable is not included.

There is an extensive manual explaining the USB C connector and a couple of possible and valid pin combinations. Most of the cables support more than one mode, therefore you have to extract the needed pins for your desired usage on your own, unfortunately that can not be done universally for all possible combinations.

No dedicated power supply is needed, all necessary power is supplied via the CR2032 battery. The battery is only discharged when a cable is connected and should last for a while.

Please note that V1 can not be used with the case.

DISCLAIMER: The item still is a prototype. It is working as intended, but funny quirks and other things are possible. It is not certified, comes as a kit and only suited for prototyping. No soldering or difficult assembly required.